Problem Causes Solutions
Printing does not start. If the machine is using
wireless LAN, failure to print
might result from a weak
wireless signal.
In [System Settings], under [Interface
Settings], select [Wireless LAN], and
then press [Wireless LAN Signal] to
check signal status. If signal quality is
poor, move the machine to a location
where radio waves can pass or
remove objects that might cause
interference.
(You can check signal status only when
using wireless LAN in the infrastructure
mode.)
Printing does not start. If the machine is using
Bluetooth interface unit,
failure to print might result
from a weak wireless signal.
Try the following:
•
Check that there are no
obstructions between the
computer, machine, and other
devices.
• Change the location of the
computer.
• Change the location of the
machine.
Printing does not start. The Bluetooth interface unit
is not installed properly.
• Check that the Bluetooth interface
unit is installed properly.
• Print the "Configuration Page",
and check that the Bluetooth
interface unit is properly
recognized. For details about
printing the "Configuration Page",
see "Printing the Configuration
Page", Printer Reference
.
Printing does not start. When there is a microwave
oven or a wireless LAN
access point near the
device, radio waves may be
interfering with the
Bluetooth's communication.
Turn off the microwave oven and the
wireless LAN access point, and then try
printing again. If printing is successful,
move the devices to a location where
they do not interfere.
4. Troubleshooting When Using the Printer Function
86
To Next Page
Loading...
