Problem Causes Solutions
Printing does not start. If the machine is using
wireless LAN, SSID settings
are incorrect.
Check using the machine's display
panel that the SSID is correctly set. See
"Wireless LAN", Network and System
Settings Reference .
Printing does not start. If the machine is using
wireless LAN, the receiver's
MAC address may be
preventing communication
with the access point.
Check access point settings when in the
infrastructure mode. Depending on the
access point, client access may be
limited by MAC address. Also, check
there are no problems in transmission
between access point and wired
clients, and between access point and
wireless clients.
Printing does not start. The login user name, login
password, or driver
encryption key is invalid.
Check the login user name, login
password, or driver encryption key.
Printing does not start. Advanced encryption has
been set using the Extended
Security function.
Check the settings of the Extended
Security function with the administrator.
Data In indicator does not
light up or flash.
If the Data In indicator does
not light up or flash even
after the print job starts, the
machine has not received
the data.
• When the machine is connected
to a computer via a cable, check
the computer print port settings
are correct. For details, see p.
88 "When the Data In Indicator
Does Not Light Up or Flash".
•
When it is networked with a
computer, contact your
administrator.
[List / Test Print] is disabled. A mechanical error might
have occurred.
Contact your service representative.
When You Cannot Print
87
To Next Page
Loading...
