ST STM32L4x6 User Manual

Power control (PWR) RM0351
152/1693 DocID024597 Rev 3
HSE oscillators are disabled. Some peripherals with the wakeup capability (I2Cx (x=1,2,3),
U(S)ARTx(x=1,2...5) and LPUART) can switch on the HSI16 to receive a frame, and switch
off the HSI16 after receiving the frame if it is not a wakeup frame. In this case, the HSI16
clock is propagated only to the peripheral requesting it.
SRAM1, SRAM2 and register contents are preserved.
The BOR is always available in Stop 0 mode. The consumption is increased when
thresholds higher than V
BOR0
are used.
I/O states in Stop 0 mode
In the Stop 0 mode, all I/O pins keep the same state as in the Run mode.
Entering the Stop 0 mode
The Stop 0 mode is entered according Section : Entering low power mode, when the
SLEEPDEEP bit in the Cortex
®
-M4 System Control register is set.
Refer to Table 24: Stop 0 mode for details on how to enter the Stop 0 mode.
If Flash memory programming is ongoing, the Stop 0 mode entry is delayed until the
memory access is finished.
If an access to the APB domain is ongoing, The Stop 0 mode entry is delayed until the APB
access is finished.
In Stop 0 mode, the following features can be selected by programming individual control
bits:
• Independent watchdog (IWDG): the IWDG is started by writing to its Key register or by
hardware option. Once started, it cannot be stopped except by a Reset. See
Section 32.3: IWDG functional description.
• real-time clock (RTC): this is configured by the RTCEN bit in the Backup domain
control register (RCC_BDCR)
• Internal RC oscillator (LSI): this is configured by the LSION bit in the Control/status
register (RCC_CSR).
• External 32.768 kHz oscillator (LSE): this is configured by the LSEON bit in the Backup
domain control register (RCC_BDCR).
Several peripherals can be used in Stop 0 mode and can add consumption if they are
enabled and clocked by LSI or LSE, or when they request the HSI16 clock: LCD, LPTIM1,
LPTIM2, I2Cx (x=1,2,3) U(S)ARTx(x=1,2...5), LPUART.
The DACx (x=1,2), the OPAMPs and the comparators can be used in Stop 0 mode, the
PVMx (x=1,2,3,4) and the PVD as well. If they are not needed, they must be disabled by
software to save their power consumptions.
The ADCx (x=1,2,3), temperature sensor and VREFBUF buffer can consume power during
the Stop 0 mode, unless they are disabled before entering this mode.
Exiting the Stop 0 mode
The Stop 0 mode is exit according Section : Entering low power mode.
Refer to Table 24: Stop 0 mode for details on how to exit Stop 0 mode.
When exiting Stop 0 mode by issuing an interrupt or a wakeup event, the HSI16 oscillator is
selected as system clock if the bit STOPWUCK is set in Clock configuration register

ST STM32L4x6 Specifications

General

Brand	ST
Model	STM32L4x6
Category	Microcontrollers
Language	English