Reset and clock control (RCC) RM0351
234/1693 DocID024597 Rev 3
6.4.23 AHB2 peripheral clocks enable in Sleep and Stop modes register
(RCC_AHB2SMENR)
Address offset: 0x6C
Reset value: 0x0005 32FF
Access: no wait state, word, half-word and byte access
Bits 31:17 Reserved, must be kept at reset value.
Bit 16 TSCSMEN: Touch Sensing Controller clocks enable during Sleep and Stop modes
Set and cleared by software.
0: TSC clocks disabled by the clock gating
(1)
during Sleep and Stop modes
1: TSC clocks enabled by the clock gating
(1)
during Sleep and Stop modes
Bits 15:13 Reserved, must be kept at reset value.
Bit 12 CRCSMEN: CRC clocks enable during Sleep and Stop modes
Set and cleared by software.
0: CRC clocks disabled by the clock gating
(1)
during Sleep and Stop modes
1: CRC clocks enabled by the clock gating
(1)
during Sleep and Stop modes
Bits 11:10 Reserved, must be kept at reset value.
Bit 9 SRAM1SMEN: SRAM1 interface clocks enable during Sleep and Stop modes
Set and cleared by software.
0: SRAM1 interface clocks disabled by the clock gating
(1)
during Sleep and Stop modes
1: SRAM1 interface clocks enabled by the clock gating
(1)
during Sleep and Stop modes
Bit 8 FLASHSMEN: Flash memory interface clocks enable during Sleep and Stop modes
Set and cleared by software.
0: Flash memory interface clocks disabled by the clock gating
(1)
during Sleep and Stop
modes
1: Flash memory interface clocks enabled by the clock gating
(1)
during Sleep and Stop
modes
Bits 7:2 Reserved, must be kept at reset value.
Bit 1 DMA2SMEN: DMA2 clocks enable during Sleep and Stop modes
Set and cleared by software during Sleep mode.
0: DMA2 clocks disabled by the clock gating
(1)
during Sleep and Stop modes
1: DMA2 clocks enabled by the clock gating
(1)
during Sleep and Stop modes
Bit 0 DMA1SMEN: DMA1 clocks enable during Sleep and Stop modes
Set and cleared by software.
0: DMA1 clocks disabled by the clock gating
(1)
during Sleep and Stop modes
1: DMA1 clocks enabled by the clock gating
(1)
during Sleep and Stop modes
1. This register only configures the clock gating, not the clock source itself. Most of the peripherals are clocked by a single
clock (AHB or APB clock), which is always disabled in Stop mode. In this case setting the bit has no effect in Stop mode.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res.
RNG
SMEN
Res.
AES
SMEN
rw rw