• p.258 "Checking the Transmission Result (Transmission File Status)"
•
p.326 "Specifying a destination using a destination list"
• p.327 "Specifying a destination using Address Book"
• p.328 "Entering a destination directly"
• p.329 "Specifying Options"
• p.332 "Confirming Transmission Results by E-mail"
• p.443 "Maximum Values"
Specifying a destination using a destination list
This section explains how to specify destinations in the machine's Address Book using LAN-Fax Driver.
• To use a destination list to specify a destination, you must insert the machine's address book data
into the destination table of the LAN-Fax Driver. See “Using the Machine's Address Book as the
LAN-Fax Destination List”.
1. Click the [Address Book] or [Specify Destination] tab.
The [Address Book] or [Specify Destination] tab appears.
2. Select the [Device Address] (or [Use device address]) check box.
Device addresses registered by selecting the [Use device address] check box in the Address Book
will appear on the [Address Book] tab.
3. The address is displayed in the [Device Address] field on the [Address Book] tab. On the
[Specify Destination] tab, enter the registration number of the Destination key in the
[Device Address:] box.
4. Click [Set as Destination].
The entered destination is added and appears in the [List of Destination:] box.
If you add a destination by mistake, click the wrong destination, and then click [Delete from List].
5. To specify more destinations, repeat steps 3 and 4.
• For details about specifying destinations, see the LAN-Fax Driver's Help.
• p.338 "Using the Machine's Address Book as the LAN-Fax Destination List"
6. Fax via Computer
326
To Next Page
