For details about how to specify the path manually, see "Locating the SMB folder manually".
For details about how to specify the path using Browse Network, see "Locating the SMB folder
using Browse Network".
17. Press [Connection Test] to check the path is set correctly.
18. Press [Exit].
If the connection test fails, check the settings, and then try again.
19. Press [OK].
20. Press [Exit].
21. Press the [User Tools/Counter] key.
• To register the name, see "Registering Names".
•
You can enter up to 64 characters for the user name.
• You can enter up to 64 characters for the password.
• You can enter a path using up to 128 characters.
• If a security-related service such as a firewall is enabled on your computer, you may be unable to
send scan files to folders. If this happens, exempt NetBIOS or the machine's IP address from
firewall protection. For details about specifying the setting, see Windows help or contact the
vendor of the software, such as the firewall.
• If User Authentication is specified, contact your administrator.
• p.227 "Registering Names"
Locating the SMB folder manually
This section describes how to locate the SMB folder manually.
1. Press [Change] under "Path".
2. Enter the path where the folder is located.
For example: if the name of the destination computer is "User", and the folder name is "Share", the
path will be \\User\Share.
Registering Folders
261
To Next Page
Loading...
