Message Causes Solutions
"Check whether there are
any network problems."
[13-25]
In [Effective Protocol], the IP
address is not enabled, or an
incorrect IP address has been
registered.
• In [System Settings], under
[Interface Settings], select
[Effective Protocol], and then
check that "IPv4" is programmed
to "Active". You can also use the
Web Image Monitor for
confirmation. See Web Image
Monitor Help.
•
In [System Settings], under
[Interface Settings], select
[Machine IPv4 Address], and
then check that the IP address is
correctly programmed. You can
also use the Web Image Monitor
for confirmation. See Web Image
Monitor Help.
• Contact your administrator.
"Check whether there are
any network problems."
[13-26]
The "Effective Protocol" and
"SIP Server IP Address"
settings are different, or an
incorrect IP address has been
registered.
• In [System Settings], under
[Interface Settings], check that the
IP address is correctly
programmed. You can also use
the Web Image Monitor for
confirmation. See Web Image
Monitor Help.
•
Contact your administrator.
Messages Displayed When Using the Facsimile Function
45
To Next Page
