NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
117
M4100 Series ProSAFE Managed Switches
lacp partner system id
Use this command to configure the 6-octet MAC Address value representing the
administrative value of the Aggregation Port’s protocol Partner’s System ID. The valid range
of <system-id> is 00:00:00:00:00:00 - FF:FF:FF:FF:FF.
Note: This command is only applicable to physical interfaces.
no lacp partner system id
Use this command to configure the default value representing the administrative value of the
Aggregation Port’s protocol Partner’s System ID.
lacp partner system priority
Use this command to configure the administrative value of the priority associated with the
Partner’s System ID. The valid range for <priority> is 0–65535.
Note: This command is applicable only to physical interfaces.
no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the
Partner’s System ID.
Default 00:00:00:00:00:00
Format lacp partner system id <system-id>
Mode Interface Config
Format no lacp partner system id
Mode Interface Config
Default 0x0
Format lacp partner system priority <priority>
Mode Interface Config
Format no lacp partner system priority
Mode Interface Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)