Management Commands
470
M4100 Series ProSAFE Managed Switches
username snmpv3 accessmode
Use this command to specify the SNMPv3 access privileges for the specified login user. The
valid accessmode values are readonly and readwrite. The <username> is the login
user name for which the specified access mode applies. The default is readwrite for the
“admin” user and readonly for all other users. You must enter the <username> in the same
case you used when you added the user. To see the case of the <username>, enter the
show users command.
• admin - readwrite
• other - readonly
no username snmpv3 accessmode
Use this command to set the SNMPv3 access privileges for the specified user as
readwrite for the “admin” user and readonly for all other users.
The <username> value
is the user name to which the specified access mode applies.
username snmpv3 authentication
Use this command to specify the authentication protocol to be used for the specified user.
The valid authentication protocols are none, md5, and sha. If you specify md5 or sha, the
login password is also used as the SNMPv3 authentication password and therefore must be
at least eight characters in length. The <username> is the user name associated with the
authentication protocol. You must enter the <username> in the same case you used when
you added the user. To see the case of the <username>, enter the show users command.
no username snmpv3 authentication
Use this command to set the authentication protocol to be used for the specified user to
none. The <username> is the user name for which the specified authentication protocol is
used.
Defaults
Format username snmpv3 accessmode <username> {readonly | readwrite}
Mode
Global Config
Format no username snmpv3 accessmode <username>
Mode Global Config
Default no authentication
Format username snmpv3 authentication <username> {none | md5 | sha}
Mode Global Config
Format no username snmpv3 authentication <username>
Mode Global Config
To Next Page
Loading...
Need help?
General
