NETGEAR M4100 Series ProSAFE

Switching Commands
115
M4100 Series ProSAFE Managed Switches
lacp partner admin state longtimeout
Use this command to set LACP partner admin state to longtimeout.
Note: This command is only applicable to physical interfaces.
no lacp partner admin state longtimeout
Use this command to set the LACP partner admin state to short timeout.
Note: This command is only applicable to physical interfaces.
lacp partner admin state passive
Use this command to set the LACP partner admin state to passive.
Note: This command is only applicable to physical interfaces.
no lacp partner admin state passive
Use this command to set the LACP partner admin state to active.
Format lacp partner admin state longtimeout
Mode Interface Config
Format no lacp partner admin state longtimeout
Mode Interface Config
Format lacp partner admin state passive
Mode Interface Config
Format no lacp partner admin state passive
Mode Interface Config