NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
182
M4100 Series ProSAFE Managed Switches
show port-security static
This command displays the statically locked MAC addresses for port.
show port-security violation
This command displays the source MAC address of the last packet discarded on a locked
port.
LLDP (802.1AB) Commands
This section describes the command you use to configure Link Layer Discovery Protocol
(LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802
LAN to advertise major capabilities and physical descriptions. The advertisements allow a
network management system (NMS) to access and display this information.
lldp transmit
Use this command to enable the LLDP advertise capability.
no lldp transmit
Use this command to return the local data transmission capability to the default.
Format show port-security static [lag <lag-intf-num> | <slot/port>]
Mode Privileged EXEC
Term Definition
MAC Address MAC Address of statically locked MAC.
Format show port-security violation [lag <lag-intf-num> | <slot/port>]
Mode Privileged EXEC
Term Definition
MAC Address MAC Address of discarded packet on locked port.
Default enabled
Format lldp transmit
Mode Interface Config
Format no lldp transmit
Mode Interface Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)