NETGEAR M4100 Series ProSAFE

Multicast VLAN Registration Commands
223
M4100 Series ProSAFE Managed Switches
mvr type
This command sets the MVR port type. When a port is set as source, it is the port to which
the multicast traffic flows using the multicast VLAN. When a port is set to receiver, it is the
port where a listening host is connected to the switch.
no mvr type
Use this command to set the MVR port type to none.
mvr vlan group
Use this command to include the port in the specific MVR group. <mVLAN> is the multicast
VLAN, and <A.B.C.D> is the IP multicast group
no mvr vlan
Use this command to exclude the port from the specific MVR group.
show mvr
This command displays global MVR settings.
Default none
Format mvr type {receiver | source}
Mode Interface Config
Format no mvr type
Mode Interface Config
Format mvr vlan <mVLAN> group <A.B.C.D>
Mode Interface Config
Format no mvr vlan <mVLAN> group <A.B.C.D>
Mode Interface Config
Format show mvr
Mode Privileged EXEC