NETGEAR M4100 Series ProSAFE

Management Commands
453
M4100 Series ProSAFE Managed Switches
transport input telnet
Use this command to regulate new Telnet sessions. If enabled, new Telnet sessions can be
established until there are no more sessions available. An established session remains
active until the session is ended or an abnormal network error ends the session.
Note: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot
be established. Use the ip telnet server enable command to
enable Telnet Server Admin Mode.
no transport input telnet
Use this command to prevent new Telnet sessions from being established.
transport output telnet
Use this command to regulate new outbound Telnet connections. If enabled, new outbound
Telnet sessions can be established until the system reaches the maximum number of
simultaneous outbound Telnet sessions allowed. An established session remains active until
the session is ended or an abnormal network error ends it.
no transport output telnet
Use this command to prevent new outbound Telnet connection from being established.
Default enabled
Format transport input telnet
Mode Line Config
Format no transport input telnet
Mode Line Config
Default enabled
Format transport output telnet
Mode Line Config
Format no transport output telnet
Mode Line Config