NETGEAR M4100 Series ProSAFE

Management Commands
494
M4100 Series ProSAFE Managed Switches
snmp-server community rw
Use this command to restrict access to switch information. The access mode is read/write
(also called private).
snmp-server enable traps violation
Use this command to enable sending new violation traps designating when a packet with a
disallowed MAC address is received on a locked port.
Note: For other port security commands, see Protected Ports Commands
on page 68.
no snmp-server enable traps violation
Use this command to disable sending new violation traps.
snmp-server enable traps
Use this command to enable the Authentication Flag.
no snmp-server enable traps
Use this command to disable the Authentication Flag.
Format snmp-server community rw <name>
Mode Global Config
Default disabled
Format snmp-server enable traps violation
Mode Interface Config
Format no snmp-server enable traps violation
Mode Interface Config
Default enabled
Format snmp-server enable traps
Mode Global Config
Format no snmp-server enable traps
Mode Global Config