Quality of Service Commands
269
M4100 Series ProSAFE Managed Switches
show classofservice trust
This command displays the current trust mode setting for a specific interface. The
<slot/port> parameter is optional and is only valid on platforms that support independent
per-port Class of Service mappings. If you specify an interface, the command displays the
port trust mode of the interface. If you do not specify an interface, the command displays the
most recent global configuration settings.
show interfaces cos-queue
This command displays the class-of-service queue configuration for the specified interface.
The slot/port parameter is optional and is only valid on platforms that support independent
per-port Class of Service mappings. If specified, the class-of-service queue configuration of
the interface is displayed. If omitted, the most recent global configuration settings are
displayed.
Format show classofservice trust [<slot/port>]
Mode Privileged EXEC
Term Definition
Non-IP Traffic
Class
The traffic class used for non-IP traffic. This is only displayed when the COS trust mode
is set to trust IP Precedence or IP DSCP (on platforms that support IP DSCP).
Untrusted Traffic
Class
The traffic class used for all untrusted traffic. This is only displayed when the COS trust
mode is set to 'untrusted'.
Format show interfaces cos-queue [<slot/port>]
Mode Privileged EXEC
Term Definition
Queue Id An interface supports n queues numbered 0 to (n-1). The specific n value is
platform-dependent.
Minimum
Bandwidth
The minimum transmission bandwidth guarantee for the queue, expressed as a
percentage. A value of 0 means bandwidth is not guaranteed and the queue operates
using best-effort. This is a configured value.
Scheduler Type Indicates whether this queue is scheduled for transmission using a strict priority or a
weighted scheme. This is a configured value.
Queue
Management
Type
The queue depth management technique used for this queue (tail drop).
To Next Page
Loading...
Need help?
General
