NETGEAR M4100 Series ProSAFE

Quality of Service Commands
308
M4100 Series ProSAFE Managed Switches
Global Config mode. The Interface Config mode command is only available on platforms that
support independent per-port Class of Service queue configuration.
• Global Config
• Interface Config
no ipv6 traffic-filter
This command removes an IPv6 ACL identified by <name> from the interface or interfaces in
a specific direction.
• Global Config
• Interface Config
show ipv6 access-lists
This command displays an IPv6 access list and all of the rules that are defined for the IPv6
ACL. Use the [<name>] parameter to identify a specific IPv6 ACL to display.
Format ipv6 traffic-filter <name> {in | {vlan <vlan-id> in}} [sequence
<1-4294967295>]
Modes
Format no ipv6 traffic-filter <name> {in | {vlan <vlan-id> in}}
Modes
Format show ipv6 access-lists [<name>]
Mode Privileged EXEC
Term Definition
Rule Number The ordered rule number identifier defined within the IPv6 ACL.
Action The action associated with each rule. The possible values are Permit or Deny.
Match All Indicates whether this access list applies to every packet. Possible values are True or
False.
Protocol The protocol to filter for this rule.
Source IP
Address
The source IP address for this rule.
Source L4 Port
Keyword
The source port for this rule.
Destination IP
Address
The destination IP address for this rule.
Destination L4
Port Keyword
The destination port for this rule.
IP DSCP The value specified for IP DSCP.
Flow Label The value specified for IPv6 Flow Label.