Switching Commands
189
M4100 Series ProSAFE Managed Switches
show lldp remote-device detail
Use this command to display detailed information about remote devices that transmit current
LLDP data to an interface on the system.
Command example:
(NETGEAR Switch) #show lldp remote-device detail 0/7
LLDP Remote Device Detail
Local Interface: 0/7
Remote Identifier: 2
Chassis ID Subtype: MAC Address
Format show lldp remote-device detail <slot/port>
Mode Privileged EXEC
Term Definition
Local Interface The interface that received the LLDPDU from the remote device.
Remote Identifier An internal identifier to the switch to mark each remote device to the system.
Chassis ID
Subtype
The type of identification used in the Chassis ID field.
Chassis ID The chassis of the remote device.
Port ID Subtype The type of port on the remote device.
Port ID The port number that transmitted the LLDPDU.
System Name The system name of the remote device.
System
Description
Describes the remote system by identifying the system name and versions of hardware,
operating system, and networking software supported in the device.
Port Description Describes the port in an alpha-numeric format. The port description is configurable.
System
Capabilities
Supported
Indicates the primary function(s) of the device.
System
Capabilities
Enabled
Shows which of the supported system capabilities are enabled.
Management
Address
For each interface on the remote device with an LLDP agent, lists the type of address the
remote LLDP agent uses and specifies the address used to obtain information related to
the device.
Time To Live The amount of time (in seconds) the remote device's information received in the
LLDPDU should be treated as valid information.