• Static - The port-channel is statically maintained.
• Dynamic - The
port-channel is dynamically maintained.
Switching Commands
125
M4100 Series ProSAFE Managed Switches
show port-channel system priority
Use this command to display the port-channel system priority.
Port Mirroring Commands
Port mirroring, which is also known as port monitoring, selects network traffic that you can
analyze with a network analyzer, such as a SwitchProbe device or other Remote Monitoring
(RMON) probe.
monitor session
This command configures a probe port and a monitored port for monitor session (port
monitoring). Use the source interface <slot/port> parameter to specify the interface
to monitor. Use rx to monitor only ingress packets or use tx to monitor only egress packets.
If you do not specify an rx or tx option, the destination port monitors both ingress and
egress packets.
Term Definition
Logical Interface Valid slot and port number separated by forward slashes.
Port-Channel
Name
The name of this port-channel (LAG). You may enter any string of up to 15 alphanumeric
characters.
Link State Indicates whether the Link is up or down.
Admin Mode May be enabled or disabled. The factory default is enabled.
Type The status designating whether a particular port-channel (LAG) is statically or
dynamically maintained.
Mbr Ports A listing of the ports that are members of this port-channel (LAG), in slot/port notation.
There can be a maximum of eight ports assigned to a port-channel (LAG).
Device Timeout For each port, lists the timeout (long or short) for Device Type (actor or partner).
Port Speed Speed of the port-channel port.
Ports Active This field lists the ports that are actively participating in the port-channel (LAG).
Load Balance
Option
The load balance option associated with this LAG. See port-channel load-balance on
page 121.
Local Preference
Mode
Indicates whether the local preference mode is enabled or disabled.
Format show port-channel system priority
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General
