Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Routing Commands

234

M4100 Series ProSAFE Managed Switches

IP Routing Commands

This section describes the commands you use to enable and configure IP routing on the

switch.

routing

This command enables IPv4 and IPv6 routing for an interface. You can view the current value

for this function with the show ip brief command. The value is labeled as “Routing

Mode.”

no routing

This command disables routing for an interface.

You can view the current value for this function with the show ip brief command. The

value is labeled as “Routing Mode.”

ip routing

This command enables the IP Router Admin Mode for the master switch.

no ip routing

This command disables the IP Router Admin Mode for the master switch.

ip address

This command configures an IP address on an interface. You can also use this command to

configure one or more secondary IP addresses on the interface. The command supports

RFC 3021 and accepts using 31-bit prefixes on IPv4 point-to-point links. This command adds

the label IP address in show ip interface.

Default disabled

Format routing

Mode Interface Config

Format no routing

Mode Interface Config

Format ip routing

Mode Global Config

Format no ip routing

Mode Global Config

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General