Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Management Commands

504

M4100 Series ProSAFE Managed Switches

no radius server host

Use this command to delete the configured server entry from the list of configured RADIUS

servers. If the RADIUS authenticating server being removed is the active server in the

servers that are identified by the same server name, then the RADIUS client selects another

server for making RADIUS transactions. If you use the auth parameter, the previously

configured RADIUS authentication server is removed from the configuration. Similarly, If you

use the acct parameter, the previously configured RADIUS accounting server is removed

from the configuration. The <ipaddr> or <dnsname> parameter must match the IP address

or DSN name of the previously configured RADIUS authentication or accounting server.

Command example:

(NETGEAR Switch) (Config) #radius server host acct 192.168.37.60

(NETGEAR Switch) (Config) #radius server host acct 192.168.37.60 port 1813

(NETGEAR Switch) (Config) #radius server host auth 192.168.37.60 name

Network1_RADIUS_Auth_Server port 1813

(NETGEAR Switch) (Config) #radius server host acct 192.168.37.60 name

Network2_RADIUS_Auth_Server

(NETGEAR Switch) (Config) #no radius server host acct 192.168.37.60

radius server key

Use this command to configure the key to be used in RADIUS client communication with the

specified server. Depending on whether the auth or acct keyword is used, the shared

secret is configured for the RADIUS authentication or RADIUS accounting server. The IP

address or host name provided must match a previously configured server. When this

command is executed, the secret is prompted.

Text-based configuration supports RADIUS server’s secrets in encrypted and non-encrypted

format. When you save the configuration, these secret keys are stored in encrypted format

only. If you want to enter the key in encrypted format, enter the key along with the encrypted

keyword. In the output of the show running config command, these secret keys are

displayed in encrypted format. You cannot show these keys in plain text format.

Note: The secret must be an alphanumeric value not exceeding 16 characters.

Format no radius server host {auth | acct} {<ipaddr> | <dnsname>}

Mode Global Config

Format radius server key {auth | acct} {<ipaddr> | <dnsname>} encrypted

Mode Global Config

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General