NETGEAR M4100 Series ProSAFE User Manual

Management Commands
501
M4100 Series ProSAFE Managed Switches
RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote
Authentication Dial-In User Service (RADIUS) server on your network for authentication and
accounting.
authorization network radius
Use this command to enable the switch to accept VLAN assignment by the radius server.
no authorization network radius
Use this command to disable the switch to accept VLAN assignment by the radius server.
radius accounting mode
Use this command to enable the RADIUS accounting function.
OSPFv2 Traps Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps are sent. If any of the OSPF trap flags are not enabled, the command displays
disabled. Otherwise, the command shows all the enabled OSPF traps’ information.
OSPFv3 Traps Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps are sent. If any of the OSPFv3 trap flags are not enabled, the command displays
disabled. Otherwise, the command shows all the enabled OSPFv3 traps’ information.
PIM Traps Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps
are sent.
Default disable
Format authorization network radius
Mode Global Config
Format no authorization network radius
Mode Global Config
Default disabled
Format radius accounting mode
Mode Global Config
Field Definition

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)