Management Commands
451
M4100 Series ProSAFE Managed Switches
no login authentication
Use this command to return to the default specified by the login authentication
command.
enable authentication
Use this command in line configuration mode to specify an authentication method list when
the user accesses a higher privilege level in remote telnet or console.
no enable authentication
Use this command to return to the default specified by the
enable authentication
command.
show serial
Use this command to display serial communication settings for the switch.
• Privileged EXEC
• User EXEC
Format no login authentication {default | <list-name>}
Mode
Line Config
Format enable authentication {default | <list-name>}
Mode Line Config
Format no enable authentication {default | <list-name>}
Mode Line Config
Format show serial
Modes
Term Definition
Serial Port Login
Timeout
(minutes)
The time, in minutes, of inactivity on a Serial port connection, after which the Switch will
close the connection. Any numeric value from 0 through 160 is allowed, the factory
default is 5. A value of 0 disables the timeout.
Baud Rate (bps) The default baud rate at which the serial port will try to connect. The available values are
1200, 2400, 4800, 9600, 19200, 38400,57600, and 115,200 baud. The factory default is
9600 baud.
Character Size
(bits)
The number of bits in a character. The number of bits is always 8.
Flow Control Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Control is
always disabled.
To Next Page
Loading...
Need help?
General
