Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Power over Ethernet Commands

319

M4100 Series ProSAFE Managed Switches

poe detection

Use this command to configure the detection type on a global basis or per interface. It is used

to configure which types of PDs will be detected and powered by the switch. There are three

options:

• ieee. Detect resistive-type devices (IEEE standard)

• pre-ieee. Legacy capacitive detection only (nonstandard)

• auto. Perform resistive detection first (IEEE standard) and capacitive detection

(pre-IEEE standard)

• Global Config

• Interface Config

no poe detection

Use this command to set the detection mode to the default on a global basis or per interface.

• Global Config

• Interface Config

poe high-power

Use this command to switch a port from 802.3af mode to high-power mode. This mode is

used to power up devices that require more power than the current IEEE 802.3af power

(more than 12.95 watts at the PD). There are three options:

• legacy. Use this mode if the device can power up (more than 12.95 watts) with higher

current and it cannot identify itself as a Class 4 device.

• pre-dot3at. Use this mode if the device cannot identify itself as a Class 4 device and it

does not have LLDP support.

• dot3at. Use this mode if the device is a Class 4 device capable of figuring out power

requirements through 2-event classification or LLDP

Default auto

Format poe detection {ieee | pre-ieee | auto}

Mode

Format no poe detection

Mode

Default dot3at

Format poe high-power {legacy | pre-dot3at | dot3at}

Mode

Interface Config

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General