Switching Commands
99
M4100 Series ProSAFE Managed Switches
storm-control broadcast rate (Interface Config)
Use this command to configure the broadcast storm recovery threshold for an interface in
packets per second. If the mode is enabled, broadcast storm recovery is active, and if the
rate of L2 broadcast traffic ingressing on an interface increases beyond the configured
threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited to the
configured threshold.
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for an
interface and disables broadcast storm recovery.
storm-control broadcast (Global Config)
This command enables broadcast storm recovery mode for all interfaces. If the mode is
enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing
on an interface increases beyond the configured threshold, the traffic will be dropped.
Therefore, the rate of broadcast traffic will be limited to the configured threshold.
no storm-control broadcast
This command disables broadcast storm recovery mode for all interfaces.
storm-control broadcast level (Global Config)
This command configures the broadcast storm recovery threshold for all interfaces as a
percentage of link speed and enables broadcast storm recovery. If the mode is enabled,
broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
Default 0
Format storm-control broadcast rate <0-14880000>
Mode Interface Config
Format no storm-control broadcast rate
Mode Interface Config
Default disabled
Format storm-control broadcast
Mode Global Config
Format no storm-control broadcast
Mode Global Config
To Next Page
Loading...
Need help?
General
