Utility Commands
355
M4100 Series ProSAFE Managed Switches
logging host remove
This command disables logging to host. See show logging hosts on page 357 for a list of host
indexes.
logging syslog
This command enables syslog logging. The <portid> parameter is an integer with a range
of 1-65535.
no logging syslog
This command disables syslog logging.
logging syslog source-interface
This command configures the syslog source interface (source IP address) for the syslog
server configuration. The IP address of the selected source interface is used for filling the
IP
header of management protocol packets. This allows security devices (firewalls) to identify
the source packets coming from the specific switch. If a source interface is not specified, the
primary IP address of the originating (outbound) interface is used as the source address.
Parameter Description
<ipaddress> |
<hostname>
The IP address or name of the logging host.
<addresstype> Indicates the type of address (IPv4, IPv6, or DNS). You can configure either an IPv4
or IPv6 address or a host name for a syslog collector among the list of servers.
<port-number> A port number from 1 to 65535.
<severitylevel> Specify this value as either an integer from 0 to 7, or symbolically through one of the
following keywords: emergency (0), alert (1), critical (2), error (3),
warning (4), notice (5), info (6), or debug (7).
Format logging host remove <hostindex>
Mode Global Config
Default disabled
Format logging syslog [port <portid>]
Mode Global Config
Format no logging syslog
Mode Global Config
To Next Page
Loading...
Need help?
General
