NETGEAR M4100 Series ProSAFE User Manual

Quality of Service Commands
305
M4100 Series ProSAFE Managed Switches
show access-lists
This command displays IP ACLs, IPv6 ACLs, and MAC access control lists information for a
designated interface and direction.
IPv6 Access Control List (ACL) Commands
This section describes the commands you use to configure IPv6 ACL settings. IPv6 ACLs
ensure that only authorized users have access to specific resources and block any
unwarranted attempts to reach network resources.
The following rules apply to IPv6 ACLs:
• The maximum number of ACLs you create is 100, regardless of type.
• The system supports only Ethernet II frame types.
• The maximum number of rules per IPv6 ACL is hardware-dependent.
Log Displays when you enable logging for the rule.
Assign Queue The queue identifier to which packets matching this rule are assigned.
Mirror Interface The slot/port to which packets matching this rule are copied.
Redirect
Interface
The slot/port to which packets matching this rule are forwarded.
Time Range
Name
Displays the name of the time-range if the ACL rule has referenced a time range.
Rule Status Status (Active/Inactive) of the ACL rule.
Format show access-lists interface <slot/port> [in | out]
Mode Privileged EXEC
Term Definition
ACL Type Type of access list (IP, IPv6, or MAC).
ACL ID Access List name for a MAC or IPv6 access list or the numeric identifier for an IP access
list.
Sequence
Number
An optional sequence number might be specified to indicate the order of this access list
relative to other access lists already assigned to this interface and direction. A lower
number indicates higher precedence order. If a sequence number is already in use for
this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If the sequence number is not specified by the
user, a sequence number that is one greater than the highest sequence number currently
in use for this interface and direction is used. Valid range is (1–4,294,967,295).
Term Definition

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)