EasyManuals Logo

NETGEAR M4100 Series ProSAFE User Manual

NETGEAR M4100 Series ProSAFE
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #293 background imageLoading...
Page #293 background image
Quality of Service Commands
293
M4100 Series ProSAFE Managed Switches
show service-policy
This command displays a summary of policy-oriented statistics information for all interfaces
in the specified direction.
The information that is shown in the following table is repeated for each interface and
direction (only those interfaces configured with an attached policy are shown).
MAC Access Control List (ACL) Commands
This section describes the commands you use to configure MAC ACL settings. MAC ACLs
ensure that only authorized users have access to specific resources and block any
unwarranted attempts to reach network resources.
The following rules apply to MAC ACLs:
The maximum number of ACLs you can create is hardware-dependent. The limit applies
to all ACLs, regardless of type.
The system supports only Ethernet II frame types.
The maximum number of rules per MAC ACL is hardware-dependent.
mac access-list extended
This command creates a MAC access control list (ACL) identified by <name>, consisting of
classification fields defined for the Layer 2 header of an Ethernet frame. The <name>
parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely
identifying the MAC access list.
If a MAC ACL by this name exists, this command enters Mac-Access-List config mode to
allow updating the existing MAC ACL.
Note: The CLI mode changes to Mac-Access-List Config mode when you
successfully execute this command.
Format show service-policy {in | out}
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Operational
Status
The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General IconGeneral
Product TypeManaged Switch
Form FactorRack-mountable
LayerLayer 2/Layer 3
ManagementWeb-based, CLI, SNMP
VLAN SupportYes
Quality of Service (QoS)Yes
Security FeaturesACLs, 802.1x
DimensionsVaries by model
WeightVaries by model
Operating Temperature32°F to 122°F (0°C to 50°C)
Storage Temperature-20° to 70° C (-4° to 158° F)
PoE SupportYes (on select models)

Related product manuals