NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
208
M4100 Series ProSAFE Managed Switches
no dos-control tcpsyn
This command sets disables TCP SYN and L4 source = 0-1023 Denial of Service protection.
dos-control tcpsynfin
This command enables TCP SYN and FIN Denial of Service protection. If the mode is
enabled, Denial of Service prevention is active for this type of attack. If packets ingress
having TCP flags SYN and FIN set, the packets will be dropped if the mode is enabled.
no dos-control tcpsynfin
This command sets disables TCP SYN & FIN Denial of Service protection.
dos-control tcpfinurgpsh
This command enables TCP FIN and URG and PSH and SEQ=0 checking Denial of Service
protections. If the mode is enabled, Denial of Service prevention is active for this type of
attack. If packets ingress having TCP FIN, URG, and PSH all set and TCP Sequence
Number set to 0, the packets will be dropped if the mode is enabled.
no dos-control tcpfinurgpsh
This command sets disables TCP FIN and URG and PSH and SEQ=0 checking Denial of
Service protections.
Format no dos-control tcpsyn
Mode Global Config
Default disabled
Format dos-control tcpsynfin
Mode Global Config
Format no dos-control tcpsynfin
Mode Global Config
Default disabled
Format dos-control tcpfinurgpsh
Mode Global Config
Format no dos-control tcpfinurgpsh
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)