Utility Commands
350
M4100 Series ProSAFE Managed Switches
• If some, but not all, of the flags in that group are enabled, the command displays
trapflags groupname flag-name.
show running-config interface
This command shows the current configuration on a particular interface. The interface could
be a physical port or a virtual port—like a LAG or VLAN. The output captures how the
configuration differs from the factory default value.
show sysinfo
This command displays switch information.
show tech-support
Use this command to display system and configuration information when you contact
technical support. The output of this command combines the output of the following
commands:
Format show running-config [all | <scriptname>]
Mode Privileged EXEC
Format show running-config interface {<slot/port>} | vlan <vlan-id> | lag
<lag-id>}
Mode Interface Config
Format show sysinfo
Mode Privileged EXEC
Term Definition
Switch
Description
Text used to identify this switch.
System Name Name used to identify the switch. The factory default is blank. To configure the system
name, see snmp-server on page 491.
System Location Text used to identify the location of the switch. The factory default is blank. To configure
the system location, see snmp-server on page 491.
System Contact Text used to identify a contact person for this switch. The factory default is blank. To
configure the system location, see snmp-server on page 491.
System Object
ID
The base object ID for the switch’s enterprise MIB.
System Up Time The time in days, hours, and minutes since the last switch reboot.
MIBs Supported A list of MIBs supported by this agent.
To Next Page
Loading...
Need help?
General
