Switching Commands
24
M4100 Series ProSAFE Managed Switches
(NETGEAR Switch)#show port advertise
Port Type Neg Operational Link Advertisement
--------- ------------------------------ ----------- ------------------------------
0/1 Gigabit - Level Enabled 1000f, 100f, 100h, 10f, 10h
0/2 Gigabit - Level Enabled 1000f, 100f, 100h, 10f, 10h
0/3 Gigabit - Level Enabled 1000f, 100f, 100h, 10f, 10h
show port
This command displays port information.
• Mirror. This port is a monitoring port. For more information, see Port Mirroring
Commands on page 125.
• PC Mbr.
This port is a member of a port-channel (LAG).
• Probe. This
port is a probe port.
show port protocol
This command displays the Protocol-Based VLAN information for either the entire system, or
for the indicated group.
Format show port {<slot/port> | all}
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Type If not blank, this field indicates that this port is a special type of port. The possible
values are:
Admin Mode The Port control administration state. The port must be enabled in order for it to be
allowed into the network. - May be enabled or disabled. The factory default is enabled.
Physical Mode The desired port speed and duplex mode. If autonegotiation support is selected, the
duplex mode and speed is set from the auto-negotiation process. Note that the
maximum capability of the port (full-duplex -100M) is advertised. Otherwise, this object
determines the port's duplex mode and transmission rate. The factory default is Auto.
Physical Status The port speed and duplex mode.
Link Status The Link is up or down.
Link Trap This object determines whether to send a trap when link status changes. The factory
default is enabled.
LACP Mode LACP is enabled or disabled on this port.
Format show port protocol {<groupid> | all}
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General
