Switching Commands
166
M4100 Series ProSAFE Managed Switches
no set igmp querier version
Use this command to set the IGMP Querier version to its default value.
set igmp querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election
process when it discovers the presence of another Querier in the VLAN. When this mode is
enabled, if the Snooping Querier finds that the other Querier’s source address is better (less)
than the Snooping Querier’s address, it stops sending periodic queries. If the Snooping
Querier wins the election, then it will continue sending periodic queries.
no set igmp querier election participate
Use this command to set the Snooping Querier not to participate in querier election but go
into non-querier mode as soon as it discovers the presence of another querier in the same
VLAN.
show igmpsnooping querier
Use this command to display IGMP Snooping Querier information. Configured information is
displayed whether or not IGMP Snooping Querier is enabled.
If you do not use the optional <vlan-id> argument, the command displays the information
that is shown in the following table.
Format no set igmp querier version
Mode Global Config
Default disabled
Format set igmp querier election participate
Mode VLAN Config
Format no set igmp querier election participate
Mode VLAN Config
Format show igmpsnooping querier [detail | vlan <vlan-id>]
Mode Privileged EXEC
Term Description
Admin Mode Indicates whether or not IGMP Snooping Querier is active on the switch.
Admin Version The version of IGMP that will be used while sending out the queries.
To Next Page
Loading...
Need help?
General
