Switching Commands
120
M4100 Series ProSAFE Managed Switches
port lacptimeout (Global Config)
This command sets the timeout for all interfaces of a particular device type (actor or
partner) to either long or short time-out.
no port lacptimeout
This command sets the timeout for all physical interfaces of a particular device type (actor
or partner) back to their default values.
port-channel adminmode
This command enables a port-channel (LAG). This command sets every configured
port-channel with the same administrative mode setting.
no port-channel adminmode
This command disables a port-channel (LAG). This command clears every configured
port-channel with the same administrative mode setting.
port-channel linktrap
This command enables link trap notifications for the port-channel (LAG). The interface is a
logical slot/port for a configured port-channel. This command enables link trap notifications
for the port-channel (LAG).
The interface is a logical <slot/port> for a configured port-channel. The option all
enables link trap notifications for all the configured port-channels. Instead of <slot/port>,
you can use lag
<lag-group-id> as an alternate way to specify the LAG interface, in
which
<lag-group-id> is the LAG port number.
Default long
Format port lacptimeout {actor | partner} {long | short}
Mode Global Config
Format no port lacptimeout {actor | partner}
Mode Global Config
Format port-channel adminmode all
Mode Global Config
Format no port-channel adminmode [all]
Mode Global Config
To Next Page
Loading...
Need help?
General
