Green Ethernet Commands
525
M4100 Series ProSAFE Managed Switches
green-mode eee
This command enables EEE low-power idle mode on an interface or on all interfaces. It
allows both send and receive sides of a link to disable some functionality for power savings
when the port is lightly loaded. Transition to Low-Power Mode does not change the link
status. Frames in transit are not dropped or corrupted in transition to and from Low-Power
Mode.
• Interface Config
• Interface Range Config
no green-mode eee
This command disables EEE.
• Interface Config
• Interface Range Config
clear green-mode statistics
This command to clears the following for a specified <slot/port>, or for all ports:
• EEE LPI event count, and LPI duration
• EEE LPI history table entries
• Cumulative Power savings estimates
Command example:
(NETGEAR Switch) #clear green-mode statistics 0/1
Are you sure you want to clear the green mode port stats? (y/n)y
Green Mode Stats Cleared.
(NETGEAR Switch) #clear green-mode statistics all
Are you sure you want to clear the green mode port stats? (y/n)y
Green Mode Stats Cleared.
Default Disabled
Format green-mode eee
Mode
Format no green-mode eee
Mode
Format clear green-mode statistics {<slot/port> | all}
Mode
Privileged Exec
To Next Page
Loading...
