Switching Commands
149
M4100 Series ProSAFE Managed Switches
no ip arp inspection vlan logging
Use this command to disable logging of invalid ARP packets on a list of comma-separated
VLAN ranges.
ip arp inspection trust
Use this command to configure an interface as trusted for Dynamic ARP Inspection.
no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
ip arp inspection limit
Use this command to configure the rate limit and burst interval values for an interface.
Configuring none for the limit means that the interface is not rate limited for Dynamic ARP
Inspections.
Note: The user interface will accept a rate limit for a trusted interface, but
the limit will not be enforced unless the interface is configured to be
untrusted.
Format no ip arp inspection vlan <vlan-list> logging
Mode Global Config
Default enabled
Format ip arp inspection trust
Mode Interface Config
Format no ip arp inspection trust
Mode Interface Config
Default 15 pps for rate and 1 second for burst-interval
Format ip arp inspection limit {rate <pps> [burst interval <seconds>] |
none}
Mode Interface Config
To Next Page
Loading...
Need help?
General
