NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
193
M4100 Series ProSAFE Managed Switches
no lldp med transmit-tlv
Use this command to remove a TLV.
lldp med all
Use this command to configure LLDP-MED on all the ports.
no lldp med all
Use this command to remove LLDP-MD on all ports.
lldp med confignotification all
Use this command to configure all the ports to send the topology change notification.
no lldp med confignotification all
Use this command to disable all the ports to send the topology change notification.
lldp med faststartrepeatcount
Use this command to set the value of the fast start repeat count. <count> is the number of
LLDP PDUs that will be transmitted when the product is enabled. The range is 1 to 10.
Format no lldp med transmit-tlv [capabilities] [network-policy] [ex-pse]
[ex-pd] [location] [inventory]
Mode Interface Config
Format lldp med all
Mode Global Config
Format no lldp med all
Mode Global Config
Format lldp med confignotification all
Mode Global Config
Format no lldp med confignotification all
Mode Global Config
Default 3
Format lldp med faststartrepeatcount [<count>]
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)