NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
184
M4100 Series ProSAFE Managed Switches
Use port-desc to transmit the port description TLV. To configure the port description, see
description on page 20
no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command without
parameters to remove all optional TLVs from the LLDPDU.
lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs.
no lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs. Use this command to cancel inclusion of the management
information in LLDPDUs.
lldp notification
Use this command to enable remote data change notifications.
Default all optional TLVs are included
Format lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
Format no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
Default enabled
Format lldp transmit-mgmt
Mode Interface Config
Format no lldp transmit-mgmt
Mode Interface Config
Default disabled
Format lldp notification
Mode Interface Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)