Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Switching Commands

154

M4100 Series ProSAFE Managed Switches

Command example:

(NETGEAR Switch) #show ip arp inspection interfaces

Interface Trust State Rate Limit Burst Interval

(pps) (seconds)

--------------- ----------- ---------- ---------------

0/1 Untrusted 15 1

0/2 Untrusted 10 10

show arp access-list

Use this command to display the configured ARP ACLs with the rules. Giving an ARP ACL

name as the argument will display only the rules in that ARP ACL.

• Privileged EXEC

• User EXEC

Command example:

(NETGEAR Switch) #show arp access-list

ARP access list H2

permit ip host 1.1.1.1 mac host 00:01:02:03:04:05

permit ip host 1.1.1.2 mac host 00:03:04:05:06:07

ARP access list H3

ARP access list H4

permit ip host 2.1.1.2 mac host 00:03:04:05:06:08

IGMP Snooping Configuration Commands

This section describes the commands you use to configure IGMP snooping. The software

supports IGMP Versions 1, 2, and 3. The IGMP snooping feature can help conserve

bandwidth because it allows the switch to forward IP multicast traffic only to connected hosts

that request multicast traffic. IGMPv3 adds source filtering capabilities to IGMP versions 1

and 2.

Rate Limit The configured rate limit value in packets per second.

Burst Interval The configured burst interval value in seconds.

Format show arp access-list [<acl-name>]

Mode

Term Definition

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General