Quality of Service Commands
306
M4100 Series ProSAFE Managed Switches
ipv6 access-list
This command creates an IPv6 access control list (ACL) identified by <name>, consisting of
classification fields defined for the IP header of an IPv6 frame. The <name> parameter is a
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6
access list.
If an IPv6 ACL by this name exists, this command enters IPv6-Access-List config mode to
allow updating the existing IPv6 ACL.
Note: The CLI mode changes to IPv6-Access-List Config mode when you
successfully execute this command.
no ipv6 access-list
This command deletes the IPv6 ACL identified by <name> from the system.
ipv6 access-list rename
This command changes the name of an IPv6 ACL. The <name> parameter is the name of an
existing IPv6 ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1
to 31 characters uniquely identifying the IPv6 access list.
This command fails is an IPv6 ACL by the name <newname> already exists.
{deny | permit} (IPv6)
This command creates a new rule for the current IPv6 access list. Each rule is appended to
the list of configured rules for the list.
Note: The no form of this command is not supported because the rules
within an IPv6 ACL cannot be deleted individually. Rather, the entire
IPv6 ACL must be deleted and respecified.
Format ipv6 access-list <name>
Mode Global Config
Format no ipv6 access-list <name>
Mode Global Config
Format ipv6 access-list rename <name> <newname>
Mode Global Config
To Next Page
Loading...
Need help?
General
