Utility Commands
358
M4100 Series ProSAFE Managed Switches
logging persistent
Use this command to configure the persistent logging for the switch. You can specify the
<severitylevel> value as either an integer from 0 to 7 or symbolically through one of the
following keywords: emergency (0), alert (1), critical (2), error (3), warning (4),
notice (5), info (6), or debug (7).
no logging persistent
Use this command to disable the persistent logging in the switch.
Email Alerting and Mail Server Commands
logging email
This command enables email alerting and sets the lowest severity level for which log
messages are emailed. If you specify a severity level, log messages at or above this severity
level, but below the urgent severity level, are emailed in a non-urgent manner by collecting
them together until the log time expires. You can specify the <severitylevel> value as
either an integer from 0 to 7 or symbolically through one of the following keywords:
emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6),
or debug (7).
Term Definition
Number of Traps
Since Last Reset
The number of traps since the last boot.
Trap Log
Capacity
The number of traps the system can retain.
Number of Traps
Since Log Last
Viewed
The number of new traps since the command was last executed.
Log The log number.
System Time Up How long the system had been running at the time the trap was sent.
Trap The text of the trap message.
Default Disable
Format logging persistent <severitylevel>
Mode Global Config
Format no logging persistent
Mode Global Config
To Next Page
Loading...
Need help?
General
