Management Commands
507
M4100 Series ProSAFE Managed Switches
no radius server timeout
Use this command to set the timeout global parameter to the default value.
show radius
Use this command to display the values configured for the global parameters of the RADIUS
client.
Command example:
(NETGEAR Switch)#show radius
Number of Configured Authentication Servers............. 32
Number of Configured Accounting Servers................. 32
Number of Named Authentication Server Groups............ 15
Number of Named Accounting Server Groups................ 3
Number of Retransmits................................... 4
Format no radius server timeout
Mode Global Config
Format show radius
Mode Privileged EXEC
Field Definition
Number of Configured
Authentication Servers
The number of RADIUS Authentication servers that have been configured.
Number of Configured
Accounting Servers
The number of RADIUS Accounting servers that have been configured.
Number of Named
Authentication Server
Groups
The number of configured named RADIUS server groups.
Number of Named
Accounting Server Groups
The number of configured named RADIUS server groups.
Number of Retransmits The configured value of the maximum number of times a request packet is
retransmitted.
Time Duration The configured timeout value, in seconds, for request retransmissions.
RADIUS Accounting Mode A global parameter to indicate whether the accounting mode for all the servers
is enabled or not.
RADIUS Attribute 4 Mode A global parameter to indicate whether the NAS-IP-Address attribute has been
enabled to use in RADIUS requests.
RADIUS Attribute 4 Value A global parameter that specifies the IP address to be used in the
NAS-IP-Address attribute to be used in RADIUS requests.