Utility Commands
430
M4100 Series ProSAFE Managed Switches
Command example:
(NETGEAR Switch) #show sflow receivers 1
Receiver Index................................. 1
Owner String...................................
Time out....................................... 0
IP Address:.................................... 0.0.0.0
Address Type................................... 1
Port........................................... 6343
Datagram Version............................... 5
Maximum Datagram Size.......................... 1400
show sflow samplers
Use this command to display the sFlow sampling instances created on the switch.
Address Type The sFlow receiver IP address type. For an IPv4 address, the value is 1 and for an IPv6
address, the value is 2.
Datagram
Version
The sFlow protocol version to be used while sending samples to sFlow receiver.
Format show sflow samplers
Mode Privileged EXEC
Field Description
Sampler Data
Source
The sFlowDataSource (slot/port) for this sFlow sampler. This agent will support Physical
ports only.
Receiver Index The sFlowReceiver configured for this sFlow sampler.
Packet Sampling
Rate
The statistical sampling rate for packet sampling from this source.
Max Header Size The maximum number of bytes that should be copied from a sampled packet to form a
flow sample.
Field Description
To Next Page
Loading...
Need help?
General
