Switching Commands
86
M4100 Series ProSAFE Managed Switches
no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state
machine on this port to the default values. Depending on the token used, the corresponding
default values are set.
dot1x unauthenticated-vlan
Use this command to configure the unauthenticated VLAN associated with that port. The
unauthenticated VLAN ID can be a valid VLAN ID from 0-Maximum supported VLAN ID. The
unauthenticated VLAN must be statically configured in the VLAN database to be operational.
By default, the unauthenticated VLAN is 0, that is, invalid and not operational.
no dot1x unauthenticated-vlan
This command resets the unauthenticated-vlan associated with the port to its default value.
quiet-period The value, in seconds, of the timer used by the authenticator state machine on this port
to define periods of time in which it will not attempt to acquire a supplicant. The
quiet-period must be a value in the range 0 - 65535.
tx-period The value, in seconds, of the timer used by the authenticator state machine on this port
to determine when to send an EAPOL EAP Request/Identity frame to the supplicant. The
quiet-period must be a value in the range 1 - 65535.
supp-timeout The value, in seconds, of the timer used by the authenticator state machine on this port
to timeout the supplicant. The supp-timeout must be a value in the range 1 - 65535.
server-timeout The value, in seconds, of the timer used by the authenticator state machine on this port
to timeout the authentication server. The supp-timeout must be a value in the range 1 -
65535.
Format no dot1x timeout {guest-vlan-period | reauth-period | quiet-period |
tx-period | supp-timeout | server-timeout}
Mode Interface Config
Default 0
Format dot1x unauthenticated-vlan <vlan id>
Mode Interface Config
Format no dot1x unauthenticated-vlan
Mode Interface Config
Tokens Definition
To Next Page
Loading...
Need help?
General
