Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Quality of Service Commands

286

M4100 Series ProSAFE Managed Switches

no policy-map

This command eliminates an existing DiffServ policy. The <policyname> parameter is the

name of an existing DiffServ policy. This command might be issued at any time. If the policy is

referenced by one or more interface service attachments, this delete attempt fails.

policy-map rename

This command changes the name of a DiffServ policy. The <policyname> is the name of an

existing DiffServ class. The <newpolicyname> parameter is a case-sensitive alphanumeric

string from 1 to 31 characters uniquely identifying the policy.

DiffServ Service Commands

Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which you

specified by using the policy commands, to an interface in the incoming direction

The service commands attach a defined policy to a directional interface. You can assign only

one policy at any one time to an interface in the inbound direction. DiffServ is not used in the

outbound direction.

This set of commands consists of service addition/removal.

The CLI command root is service-policy.

service-policy

This command attaches a policy to an interface in the inbound direction. The <policyname>

parameter is the name of an existing DiffServ policy. This command causes a service to

create a reference to the policy.

Note: This command effectively enables DiffServ on an interface in the

inbound direction. There is no separate interface administrative

'mode' command for DiffServ.

Format no policy-map <policyname>

Mode Global Config

Format policy-map rename <policyname> <newpolicyname>

Mode Global Config

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General