NETGEAR M4100 Series ProSAFE

Management Commands
520
M4100 Series ProSAFE Managed Switches
script show
Use this command to display the contents of a script file, which is named <scriptname>.
script validate
Use this command to validate a script file by parsing each line in the script file, where
<scriptname> is the name of the script to validate. The validate option is intended to be
used as a tool for script development. Validation identifies potential problems. It might not
identify all problems with a script on a device.
Pre-Login Banner and System Prompt Commands
This section describes the commands you use to configure the pre-login banner and the
system prompt. The pre-login banner is the text that displays before you login at the User:
prompt.
copy (pre-login banner)
Use the copy command to upload or download the CLI banner from the switch. You can
specify local URLs by using TFTP, Xmodem, Ymodem, or Zmodem.
Note: <ip6address> is also a valid parameter for routing packages that
support IPv6.
Term Definition
Configuration Script Name of the script.
Size Privileged EXEC
Format script show <scriptname>
Mode Privileged EXEC
Term Definition
Output Format line <number>: <line contents>
Format script validate <scriptname>
Mode Privileged EXEC