NETGEAR M4100 Series ProSAFE User Manual

Management Commands
463
M4100 Series ProSAFE Managed Switches
no ip http authentication
Use this command to restore the authentication methods to the default.
ip http session maxsessions
Use this command to limit the number of allowable unsecure HTTP sessions. Zero is the
configurable minimum.
no ip http session maxsessions
Use this command to restore the number of allowable unsecure HTTP sessions to the default
value.
ip http session soft-timeout
Use this command to configure the soft time-out for unsecure HTTP sessions in minutes.
Configuring this value to zero sets an infinite soft time-out. When this time-out expires the
user must reauthenticate. This timer begins on initiation of the web session and is restarted
with each access to the switch.
Tacacs Uses the list of all TACACS servers for authentication.
None Uses no authentication.
Format no ip http authentication <method1> [<method2> ...]
Mode Global Config
Default 16
Format ip http session maxsessions <0-16>
Mode Privileged EXEC
Format no ip http session maxsessions
Mode Privileged EXEC
Default 5
Format ip http session soft-timeout <0-60>
Mode Privileged EXEC
Term Definition

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)