EasyManua.ls Logo

NETGEAR M4100 Series ProSAFE

NETGEAR M4100 Series ProSAFE
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Log Messages
556
M4100 Series ProSAFE Managed Switches
O/S Support
OS USL: failed to sync L3 Route table on unit=
x
Could not synchronize unit x due to a
transport failure or API issue on remote
unit. A synchronization retry will be issued
OS USL: failed to sync initiator table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote
unit. A synchronization retry will be issued
OS USL: failed to sync terminator table on
unit=x
Could not synchronize unit x due to a
transport failure or API issue on remote
unit. A synchronization retry will be issued
OS USL: failed to sync ip-multicast table on
unit=x
Could not synchronize unit x due to a
transport failure or API issue on remote
unit. A synchronization retry will be issued
Table 55. OSAPI Log Messages
Component Message Cause
OSAPI ftruncate failed – File resides on a
read-only file system.
ftruncate is called to correctly set the file’s
size in the file system after a write. The file
system is R/W so this msg indicates that
the file system may be corrupted.
OSAPI ftruncate failed – File is open for reading
only.
ftruncate is called to correctly set the file’s
size in the file system after a write. The file
is opened for R/W so this msg indicates
that the file system may be corrupted.
OSAPI ftruncate failed – File descriptor refers to a
file on which this operation is impossible.
ftruncate is called to correctly set the file’s
size in the file system after a write. This
msg indicates that the file system may be
corrupted.
OSAPI ftruncate failed – Returned an unknown
code in errno.
ftruncate is called to correctly set the file’s
size in the file system after a write. This
msg indicates that the file system may be
corrupted.
OSAPI ping: bad host! The address requested to ping cannot be
converted to an Internet address.
OSAPI osapiTaskDelete: Failed for (XX) error YYY The requested task cannot be deleted
because: the requested deletion is called
from an ISR, the task is already deleted, or
the task ID is invalid.
Table 54. System General Error Messages
Component Message Cause

Table of Contents

Related product manuals