Routing Commands
242
M4100 Series ProSAFE Managed Switches
Command example:
(NETGEAR Switch) #show ip brief
Default Time to Live........................... 64
Routing Mode................................... Disabled
Maximum Next Hops.............................. 4
Maximum Routes................................. 6000
ICMP Rate Limit Interval....................... 1000 msec
ICMP Rate Limit Burst Size..................... 100 messages
ICMP Echo Replies.............................. Enabled
ICMP Redirects................................. Enabled
show ip interface
This command displays all pertinent information about the IP interface.
• Privileged EXEC
• User EXEC
Format show ip interface {<slot/port> | vlan <1-4093> | loopback <0-7>}
Modes
Term Definition
Routing Interface
Status
Determine the operational status of IPv4 routing Interface. The possible values are Up or
Down.
Primary IP
Address
The primary IP address and subnet masks for the interface. This value appears only if
you configure it.
Secondary IP
Address
One or more secondary IP addresses and subnet masks for the interface. This value
appears only if you configure it.
Method Shows whether the IP address was configured manually or acquired from a DHCP
server.
Routing Mode The administrative mode of router interface participation. The possible values are enable
or disable. This value is configurable.
Administrative
Mode
The administrative mode of the specified interface. The possible values of this field are
enable or disable. This value is configurable.
Forward Net
Directed
Broadcasts
Displays whether forwarding of network-directed broadcasts is enabled or disabled. This
value is configurable.
Proxy ARP Displays whether Proxy ARP is enabled or disabled on the system.
Local Proxy ARP Displays whether Local Proxy ARP is enabled or disabled on the interface.
Active State Displays whether the interface is active or inactive. An interface is considered active if its
link is up and it is in forwarding state.
To Next Page
Loading...
Need help?
General
