Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Quality of Service Commands

283

M4100 Series ProSAFE Managed Switches

no class

This command deletes the instance of a particular class and its defined treatment from the

specified policy. <classname> is the names of an existing DiffServ class.

Note: This command removes the reference to the class definition for the

specified policy.

mark cos

This command marks all packets for the associated traffic stream with the specified Class of

Service value in the priority field of the 802.1p header (the only tag in a single tagged packet

or the first or outer 802.1Q tag of a double VLAN tagged packet). If the packet does not

already contain this header, one is inserted. The CoS value is an integer from 0 to 7.

mark cos-as-sec-cos

This command marks outer VLAN tag priority bits of all packets as the inner VLAN tag

priority, marking CoS as Secondary CoS. This essentially means that the inner VLAN tag

CoS is copied to the outer VLAN tag CoS.

mark ip-dscp

This command marks all packets for the associated traffic stream with the specified IP DSCP

value.

The <dscpval> value is specified as either an integer from 0 to 63, or symbolically through

one of the following keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33,

af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, or ef.

Format no class <classname>

Mode Policy-Map Config

Default 1

Format mark-cos <0-7>

Mode Policy-Class-Map Config

Incompatibilities Drop, Mark IP DSCP, IP Precedence, Police

Format mark-cos-as-sec-cos

Mode Policy-Class-Map Config

Incompatibilities Drop, Mark IP DSCP, IP Precedence, Police

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General