Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Switching Commands

180

M4100 Series ProSAFE Managed Switches

port-security mac-address

This command adds a MAC address to the list of statically locked MAC addresses. The

<vid> is the VLAN ID.

no port-security mac-address

This command removes a MAC address from the list of statically locked MAC addresses.

port-security mac-address move

This command converts dynamically locked MAC addresses to statically locked addresses.

port-security mac-address sticky

This command enables sticky mode Port MAC Locking on a port. If accompanied by a MAC

address and a VLAN id (for interface config mode only), it adds a sticky MAC address to the

list of statically locked MAC addresses. These sticky addresses are converted back to

dynamically locked addresses if sticky mode is disabled on the port. The <vid> is the VLAN

ID. The Global command applies the sticky mode to all valid interfaces (physical and LAG).

There is no global sticky mode as such.

Sticky addresses that are dynamically learned display in the output of the show running

config command as port-security mac-address sticky <mac> <vid> entries.

This distinguishes them from static entries.

• Global Config

• Interface Config

Format port-security mac-address <mac-address> <vid>

Mode

Interface Config

Format no port-security mac-address <mac-address> <vid>

Mode Interface Config

Format port-security mac-address move

Mode Interface Config

Format port-security mac-address sticky [<mac-address> <vid>]

Modes

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General