Utility Commands
365
M4100 Series ProSAFE Managed Switches
System Utility and Clear Commands
This section describes the commands you use to help troubleshoot connectivity issues and to
restore various configurations to their factory defaults.
traceroute
Use the this command to discover the routes that packets actually take when traveling to
their destination through the network on a hop-by-hop basis. Traceroute continues to provide
a synchronous response when initiated from the CLI.
• count: 3 probes
• interval: 3 seconds
• size: 0 bytes
• port: 33434
• maxTtl: 30 hops
• maxFail: 5 probes
• initTtl: 1 hop
Using the options described below, you can specify the initial and maximum time-to-live
(TTL) in probe packets, the maximum number of failures before termination, the number of
probes sent for each TTL, and the size of each probe.
Email Alert
Security Protocol
The security protocol (TLS or none) the switch uses to authenticate with the SMTP
server.
Email Alert
Username
The username the switch uses to authenticate with the SMTP server.
Email Alert
Password
The password the switch uses to authenticate with the SMTP server.
Default
Format traceroute {<ip-address> | <hostname>} [initTtl <initTtl>] [maxTtl
<maxTtl>] [maxFail <maxFail>] [interval <interval>] [count <count>]
[port <port>] [size <size>] [source {<ip-address> | <slot/port> |
loopback <0-7>}]
Mode Privileged EXEC
Parameter Description
{<ip-address> | <hostname>} The <ip-address> value must be a valid IP address. The
<hostname> value must be a a valid host name.
[initTtl <initTtl>] As an option, specify the initial time-to-live (TTL), the maximum
number of router hops between the local and remote system.
Range is 0–255.
[maxTtl <maxTtl>] As an option, specify the maximum TTL. Range is 1–255.
Term Definition
To Next Page
Loading...
Need help?
General
